Filter
Top Products
19
Using Web Browser (continued)
E-mail setup page
With this projector, if a problem occurs or if the lamp usage time reaches a set value, an e-mail message can be
sent to one or more preset e-mail addresses (maximum two addresses).
Click [Detailed set up], then [E-mail set up] to display the E-mail setup page.
1
Select ENABLE to use the e-mail function.
2
Enter the IP address or server name of the e-mail
server (SMTP). The DNS server must be set if the
server name is entered.
3
Enter the e-mail address of the projector.
(maximum 63 characters)
4
The user can enter the location of, for example,
the installed projector so that the recipient may
easily identify the originator of the e-mail.
(maximum 63 characters)
5
The user can modify the minimum time interval
of temperature warning mail. The default value
is 60 minutes. In this case, the user cannot send
another mail for 60 minutes after sending previous
temperature warning mail even the set warning
temperature is reached again.
6
Select the temperature of the intake sensor at
which to send a warning message.
1
Enter the E-mail Address1 of your desired recipient.
2
Select the conditions for sending e-mail.
MAIL CONTENTS: Select [NORMAL] or [SIMPLE].
ERROR: An error is detected by self-diagnosis.
LAMP1-4 RUNTIME: Remaining lamp service time has reached the value set in the eld.
INTAKE AIR TEMPERATURE: Intake air temperature has reached the value set in the eld.
6
5
4
3
2
1
2
1