Filter
Top Products
Setting
64
- ENGLISH
Settings
Attention
Be sure to note the new Logo PIN code and keep it on
z
hand. If you lost the number, you could no longer change
the Logo PIN code setting.
Picture in Picture
This function is used to project two images
simultaneously by placing a separate small sub
screen within or next to the main screen.
Press ▲▼ to select [Picture in 1 )
Picture
*
].
You can also press the <P IN P>button on
z
the remote control for more than 3 seconds to
display [Picture in Picture] menu.
Press the <ENTER> button to access 2 )
the submenu.
Only the sound from the source of Main picture
z
is valid, while the source of Sub picture cannot
output the sound.
* (Only for EZ570 series, EW630 series and EW530
series.)
User setting
J
Show the selected mode ([Off/User 1-5]) and its status
([Stored /Free/ Adj.]). [User 1] and [User 2] have
stored default values.
P in P/P by P
J
P IN P
Provide the images of Main picture
and Sub picture at the ratio of
Screen aspect in the Screen Menu.
P by P
Provide the images of Main picture
and Sub picture at the ratio of 4:3.
Note
In [P in P] the larger picture is main picture, and the
z
smaller one is sub picture; in [P by P], the left picture is
main picture, and the right one is sub picture.
Main picture/ Sub picture
J
Press ▲▼◄► to adjust the display 1 )
position of active frame indicated in
white.
The frame will disappear after 10 seconds or
z
when the <ENTER> button is pressed.
Input
Select an input from Input 1-3.
Source
Select an input source.
Size
Select the display size.
Position
Press the <ENTER> button at
Position and the display position
setting screen appears.
Selecting the Main picture or the Sub picture
z
During Picture in Picture mode, and being
undisplayed On Screen Menu, press the <ENTER>
button to select Main or Sub picture. (A red frame
will be displayed on the selected picture.)
Switching Input and Source
z
When selecting Main picture or Sub picture, input
and source can be set by pressing the <INPUT>
button on the side control or INPUT 1/2/3 button
on the remote control. Operation on the On Screen
Menu is not necessary.
Frame lock
J
Set the Frame Lock to Main picture or Sub picture.
Reset
J
Press the <ENTER> button at [Reset] to display a
conrmation box. To reset, press the <ENTER> button
at [Yes].
Mode free
J
Delete the data stored in the Mode and return to [Free].
Use the ▲▼ buttons to select [Mode free] and press
the <ENTER> button to show the [Where to free?]
dialog box. Move the highlight to one of the mode
([User 1 - 5]) which you want to delete and press the
<ENTER> button. Then the conrmation box appears.
To delete, select [Yes].
Store
J
Store the adjusted data in the [User 1-5]. Use the
▲▼ buttons to select [Store] and press the <ENTER>
button to show the [Where to store?] dialog box. Move
the highlight to one of the mode (User 1 - 5) which
you want to store and press the <ENTER> button.
Then the conrmation box appears. To store adjusted
data, select [Yes].
Note
The [Picture in Picture] function is not available
z
depending on the input signals and the selected input
terminals.
When the input signal(s) is/are incompatible,
z
X
mark will
be displayed on the Main/Sub picture.