Filter
Top Products
Network
ENGLISH -
83
Settings
E-mail set up page
J
With this projector, if a problem occurs or if the lamp usage time reaches a set value, an e-mail message can be
sent to one or more preset e-mail addresses (maximum two addresses).
Click [Detailed set up], then [E-mail set up] to display the E-mail setup page.
1
Select Enable to use the e-mail function.
2
Enter the IP address or server name of the
e-mail server (SMTP). The DNS server must be
set if the server name is entered.
3
Enter the e-mail address of the projector.
(maximum 63 characters)
4
The user can enter the location of, for
example, the installed projector so that the
recipient may easily identify the originator of
the e-mail.
(maximum 63 characters)
5
The user can modify the minimum time
interval of temperature warning mail. The
default value is 60 minutes. In this case, the
user cannot send another mail for 60 minutes
after sending previous temperature warning
mail even the set warning temperature is
reached again.
6
Select the temperature of the intake sensor at
which to send a warning message.
1
Enter the E-mail Address1 of your desired recipient.
2
Select the conditions for sending e-mail.
MAIL CONTENTS: Select [NORMAL] or [SIMPLE].
ERROR: An error is detected by self-diagnosis.
LAMP RUNTIME: Remaining lamp service time has reached the value set in the eld.
INTAKE AIR TEMPERATURE: Intake air temperature has reached the value set in the eld.
6
5
4
3
2
1
2
1