Filter
Top Products
19
Other operations for connection (cont.)
Even if there are two or more projectors with the same name, an ID ([Proj] + 4-digit number) is assigned to each projector to
enable the projectors to be identified.
When you click [ID Search], a search for the projector of the specified ID is carried out from among the projectors that are
presently switched on, from all network numbers other than [U].
It is necessary to know ID in advance. When input selection is switched to [NETWORK] on a projector, the ID appears on the
upper right of the projection screen for approximately 5 seconds. If you write down the ID displayed in the [ID] column of the
[Details] screen on the <Select Access Port> window in advance, you can search a projector by the ID from next time.
Click [Select Access Port] in the menu.
The <Select Access Port> window appears.
1
Enter four figures of desired projector’s ID, and click [Search].
Start Searching.
3
When the projector of the applicable ID is found, the computer will be connected to
that projector, and the status display of the menu bar will turn green.
If appropriate ID is not found, an error message appears.
4
Click [ID Search].
<Projector ID Search> window appears.
2
Searching by projector’s ID
For procedures for displaying menus, see page 21.