Panasonic PT-FW300NTU Projector User Manual


 
Technical Information
ENGLISH - 55
Appendix
You can remotely operate the projector from the outside the remote control range by connecting to the REMOTE
terminal.
J Pin assignments and signal names
J LAMP switching
J Switching input signals
REMOTE terminal
Pin No. Signal name Contents
A
GND Ground
B
POWER POWER ON
C
INPUT SEL3 Select input signal 3
D
NC
E
INPUT SEL1 Select input signal 1
F
INPUT SEL2 Select input signal 2
G
Connect internally
H
I
ENABLE Control by external contact
Pin No. Settings
B - A
Short Open
Operation On Off
Pin No. Settings
C - A
Open Open Open Short Short Open
E - A
Open Short Open Open Short Short
F - A
Open Open Short Open Open Short
Input signal
COMPUTER1 COMPUTER2 DVI VIDEO S-VIDEO NETWORK
NOTE:
When pin A and pin I are short-circulated, the buttons on the projector’s control panel, power and INPUT SELECT
buttons on the remote control cannot be used. In addition, the RS-232C commands and network functions that
correspond to these functions cannot be used either.
While pin I is “Open”, do not short-circuit pin A, B, C, E and F. The projector would reject all the signals from the
remote control.