Panasonic PT-VX400U Projector User Manual


 
Setting
58
- ENGLISH
Settings
PIN code change
J
The PIN code can be changed to your desired four-
digit number.
Press ▲▼ to select [PIN code change] 1 )
and then Press <SELECT> button.
Current Pin code dialog box appears.
z
Press ▲▼ to enter the current code. 2 )
Press ► button to x the number and
move the red frame pointer to the next
box.
The New PIN code input dialog box appears.
z
Repeat these steps to set a new PIN 3 )
code.
Fan
Press ▲▼ to select [Fan] and then 1 )
Press <SELECT> button.
Press ▲▼ to select one option.2 )
This function provides the following options in
z
the cooling fans’ operation when the projector is
turned off.
L1
Normal operation
L2
Slower and lower-sound than
the normal operation (L1), but
it takes more time to cool the
projector down.
Fan control
Press ▲▼ to select [Fan control] and 1 )
then Press <SELECT> button.
Press ▲▼ to select one among 2 )
options as below.
Choose the running speed of cooling fans from
z
the following options according to the ground
elevation under which you use the projector.
Off
Normal speed.*
1
On1
Faster than Off mode.*
2
On2
Faster than On 1 mode.*
3
Set this function to [Off] when using the projector *1 :
in non-high altitude environment.
Select this mode when using the projector in high *2 :
altitudes (about 1,200 meters or more above
the sea level) where the fans have less cooling
effect.
Select this mode when using the projector in *3 :
higher altitudes ( than above where the fans
have lesser cooling effect).
Note
Failure to set the running speed of cooling fans
z
properly may affect the projector life.
The fan noise becomes louder in [On 1] and [On 2].
z
Video delay control
This function allows you to make a digital processing
of a projected image faster.
Press ▲▼ to select [Video delay 1 )
control] and then Press the <SELECT>
button.
Press ▲▼ to select one item between 2 )
On and Off.
Note
[Noise reduction] and [Progressive] can not be
z
selected when Video delay control function is set to
[On].
Filter counter
This function is used to set a frequency for the lter
replacement.
Press ▲▼ to select [Filter counter].1 )
Press ►or the <SELECT> button to 2 )
access the submenu items.
Filter counter
J
Show the total accumulated time of the lter use timer
setting.
Timer
J
To set a timer. When the projector reaches the
selected time the lter warning icon appears on the
screen.
Press ▲▼ to select [Timer] and then 1 )
press the <SELECT> button.