Filter
Top Products
16
■ PPP Type Connection 1 (P to P ACCESS)
To use this mode, match the IP address of the PC with the address of the WJ-NT104.
The WJ-NT104 permits PPP (Point-to-Point Protocol) connection via a public line or the ISDN by connecting it to a modem
or a terminal adapter (TA).
PC
(Windows 95 etc.)
RS-232C
cable
RS-232C
cable
Modem/TA
WJ-NT104
Modem/TA
Public lines
Camera (max. 4)
● Setup Procedures
To set up the PPP connection, access the WJ-NT104 from a PC via a LAN and open the ADMINISTRATOR SETUP PAGE.
If the WJ-NT104 is already connected to a LAN, go to the Location bar and specify http://192.168.0.10 (or IP address set previ-
ously)/hwsetup.html to display the ADMINISTRATOR SETUP PAGE. If it is not yet connected to a LAN, connect to the LAN
following the procedures described under "PREPARATIONS" (p. 12) and specify hwsetup.html to open the ADMINISTRATOR
SETUP PAGE.
q On the ADMINISTRATOR SETUP PAGE, click the
[SERIAL PORT] button to open the SERIAL PORT
SETUP dialog box.
RS-232C SETUP
TYPE: Select MODEM/TA
BAUD RATE, DATA BIT, STOP BIT, PARITY, USE
FLOW CONTROL:
Set these items to match the settings of the
modem/TA used. If the settings of the modem/
TA are unknown, set 57 600 bps (see note), 8
bit, 1 bit, NONE, and NONE, respectively.
Note: Set a baud rate (net nec.) close to that of the
modem or TA connected. If there is a large differ-
ence, it may take much longer for images to
appear.
w Click the [SET&REBOOT] button to save the settings.