Filter
Top Products
6
Table 3
Line Dialer Configuration Options for the United Kingdom
Blind Dial Paus: 2sec
Nxt 2sec
Blind Dial Pause. Set to 2 seconds. Read-only and cannot be changed. Only appears when Dial Tone Detect is disabled.
The AT command is S6=2 and cannot be changed.
NoAnswer Timout: 45sec
Nxt 45sec 30sec 60sec
No Answer Abort Time-out. Set to 45 seconds.
The AT command is S-Register S7=
n
, where
n
is a value from 1 to 60 in 1-second increments.
Auto Make Busy: Disable
Nxt Disable
Auto Make Busy. Set to Disable. Read-only and cannot be changed. Only appears when using 3811
Plus
modems.
The AT command is S40=0 and cannot be changed.
MakeBusyVia DTR: Disable
Nxt Disable
Make Busy Via DTR. Set to Disable. Read-only and cannot be changed.
The AT command is S69=0 and cannot be changed.
Table 4
Dial Line Configuration Options for the United Kingdom
Dial Line Rate: 2400(V22bis)
Nxt 2400(V22bis) 1200(V22) 1200(212A) 0–300(V21) 0–300(103J)
Dial Line Rate. Does not support the Bell modulation schemes of 1200 (212A) and 0–300 (103J).
NOTE: The rates and modulations displayed for Dial Line Rate depend on the setting of the Modulation configuration
option. The selection shown above is displayed when the Modulation configuration option is V21/V22/Bell.
The factory default is 28800(V34).
AT command for Dial Line Rate is S-Register S41=
n
, where
n
is:
6 = 2400 (V.22bis)
7 = 1200 (V.22)
10 = 0–300 (V.21)
Dial TX Level: –9 dBm
Nxt –9 dBm
Dial Transmit Level. Set to –9 dBm. Read-only and cannot be changed.
The AT commands are &I9 and &J11 and cannot be changed.
V22b Guard Tone: 1800 Hz
Nxt 1800 Hz
V.22bis Guard Tone. Set to 1800 Hz. Read-only and cannot be changed.
The AT command is &G2 and cannot be changed.
Table 5
Leased Line Configuration Options for the United Kingdom
Leased TX Level: –13 dBm
Nxt –13 dBm
Leased Transmit Level. Set to –13 dBm. Read-only and cannot be changed.
The AT command is S45=13 and cannot be changed.