Filter
Top Products
2. Hardware Installation and PC Setup
6212-A2-GB23-00 September 2005
2-3
Figure 2-1. Hardware Installation
5. Turn on your PC and any other LAN devices, such as hubs or switches.
6. Turn on the router using its power switch.
7. Verify that the router's LEDs are illuminated as shown in Tabl e 2-1.
If the LEDs are illuminated as expected, the router is working properly.
Table 2-1. LED Indicators
This LED . . . Should be:
POWER Solid green to indicate that the device is turned on. If this light is not
on, check if the power adapter is attached to the router and plugged
into an AC power source.
STATUS Solid green to indicate that the router can communicate with your ISP
via ADSL, or flashing when the router is trying to connect to your ISP.
ACTIVITY Flashing when the device is sending or receiving data over the ADSL
connection.
LAN Solid green to indicate that the device can communicate with your PC
via Ethernet, or flashing when the router is sending or receiving data
over Ethernet.
05-17712
CONSOLE
LINE
LAN 1
POWER
DEFAULT
RESET
LAN 2 LAN 3 LAN 4
Power
Switch