Filter
Top Products
3. Configuration Options
3-80 December 2002 9000-A2-GB31-00
Management MTU Size
Possible Settings: 90 – 1500
Default Setting: 1500
Specifies the Maximum Transmission Unit (MTU) for management traffic transmitted on
standard DLCIs, EDLCIs, IP tunnels, and Payload Management circuits.
90 – 1500 – Specifies the MTU size.
TS Access Management Link
Available Settings: None, PVCname
Default Setting: None
Specifies a troubleshooting management link for the special needs of network service
providers.
If the setting is changed from the management PVC name to None, the Delete the
Management PVC PVCname and the associated DLCI Record? prompt appears.
If you select:
No – The link designation is removed and the option is set to None.
Yes – The link designation is removed and the option is set to None, and the link
and its DLCI will be deleted.
Display Conditions – This option appears only when Service Type is Frame Relay.
None – Disables or does not specify a TS Access Management Link.
PVCname – Specifies the name of the TS Management PVC. This selection only appears
when a dedicated management PVC has been defined on the network frame relay link as
a DLCI with DLCI Type set to Standard.
TS Management Link Access Level
Available Settings: Level-1, Level-2, Level-3
Default Setting: Level-1
Specifies the highest access level allowed when accessing the unit via a Telnet or FTP
session when the service provider is using the TS Access Management Link.
Display Conditions – This option only appears when:
Service Type on the Easy Install screen is set to Frame Relay.
TS Access Management Link is set to a PVC name.
NOTES:
– Telnet and FTP sessions on this link are not affected by the access level set by the
Session Access Level, Login Required, or FTP Login Required option settings (see
Table 3-34, Telnet and FTP Session Options).
– Telnet and FTP sessions on this link are affected by the Telnet Session, Inactivity
Timeout, Disconnect Time and FTP Session option settings.
Level-1 – Allows Telnet or FTP access by network service providers with the capability to
view unit information, change configuration options, and run tests. This is the highest
access level allowed. Use this setting when downloading files.
Level-2 – Allows Telnet or FTP access by network service providers with the capability to
view unit information and run tests only; they cannot change configuration options.
Level-3 – Allows Telnet access by network service providers with the capability to view
unit information only; they cannot change configuration options or run tests.
Table 3-31. Node IP Options (3 of 4)