Filter
Top Products
4 June 2005 MIM2-A2-GZ42-00
3. Slide the MIM-2000F firmly into place. Do not use excessive force.
4. Secure the MIM-2000F by tightening the fastening screws on the MIM
faceplate with a flat-blade screwdriver.
Installing and Cabling SFP Transceivers
Both SFP copper and fiber optic transceivers may be installed in the MIM-2000F.
The following SFP fiber optic transceivers are available:
SFP-MMF – GigE SFP Multimode Fiber Optic Transceiver, Short Reach
SFP-SMF10 – GigE SFP Single Mode Fiber Optic Transceiver, 10Km Reach
SFP-SMF40 – GigE SFP Single Mode Fiber Optic Transceiver, 40Km Reach
SFP-SMF80 – GigE SFP Single Mode Fiber Optic Transceiver, 80Km Reach
To install SFP transceivers in the MIM-2000F:
Procedure
1. Insert an SFP transceiver into an SFP socket on the MIM-2000F.
2. Insert the LC connector of your fiber optic cable into the SFP transceiver.
3. Observing the minimum bend radius for your cable, fasten it in such a way that
it will not be kinked or snagged in the course of other cabling. If you do not
know the specifications for your cable, maintain a radius of at least ten times
the cable diameter.
4. Repeat for all the sockets you intend to use.
Managing the MIM-2000F
The configuration and monitoring of the integrated switch on the MIM-2000F is
performed through the management screens of the BSX8000 or 4929 DSLAM that
hosts this module. See the BSX8000-5 Installation Instructions or 4929 DSLAM
Installation Guide and the NMS User’s Guide.
05-17670
1
Lnk 1 Act
Lnk 2Act
MIM-2000F