Filter
Top Products
12
Switch S2-7: Reset Software Defaults.
Switch S3-7 allows the user to
reset the software configured factory defaults. This will only be needed
when using the Model 1001MC to SNMP manage your units. For more
information, please refer to the Model 1001MC Operations Manual.
Switch S2-8: Transmit Data (TD) Sampling Point.
Switch 3-8 controls
the Transmit Data (TD) sampling point.
3.2 NETLINK PLUG-AND-PLAY
The NetLink Plug-and-Play feature allows ISPs, carriers and PTTs to
quickly upgrade the link speed for a customer without requiring a visit to
re-configure the Customer Premise (CP) Model 1088. This feature also
allows service providers to set up all of the configurations at the Central
Office (on the rack cards) before installing the stand alone units, saving
time spent configuring or re-configuring DIP switches.
Note
NetLink Plug-and-Play is only available when using a rack-
mounted NetLink Model 1095RC as the CO unit.
The NetLink Plug-and-Play feature allows the user to configure the DTE
rate (bandwidth allocation, see Switches S2-1 through S2-6) of the CP
unit from the rack card at the Central Office (CO). The stand alone unit at
the Customer Premise (CP) site will automatically configure itself to the
DTE rate (Bandwidth Allocation) of the rack card. Other configuration
parameters remain in the default setting.
Follow the instructions below to activate NetLink Plug-and-Play between
CO (Model 1095RC and CP (Model 1088) units:
• Set the Model 1095RC (CO) to either Internal or External clocking
mode as defined by the application.
S3-7 Setting
On Normal Operation
Off Reset
S3-8 Setting Description
On Normal TD sampled on the falling edge of the 1088 Trans-
mit Clock (TC)
Off Invert TD sampled on the rising edge of the 1088 Transmit
Clock.