Filter
Top Products
27
28
17
18
lANDBY
POWER
0
0
PEAVE” ELECTRONICS
CDRP
ON ON
m
STANDBY POWER
PATENT
PENDlNG
26
19
BACK PANEL
REMOTE
FOOTS
WITCH
JACK
Provided for the connection of the
supplied remote footswitch. When
the footswitch is plugged into the
remote footswitch jack, the channel
select switch
[3]
must be pressed
to the “in” position for remote
selection to operate. Remote
selection of the LEAD or RHYTHM
channel (left footswitch button) or
outboard devices in the effects
loop (right footswitch button) is
possible with the remote footswitch.
sr
SNAKER
OUTPUTS
;
1.
Paralleled
VV’
output jacks for
A
connecting speaker enclosure(s) to
the amplifier (minimum: 4 ohms).
When using more than one
enclosure, be sure to calculate the
total impedance and set the
impedance switch
[28]
accordingly.
(See section on IMPEDANCE
SWITCH.)
Important: Use only high quality,
UNshielded
cable for speaker
connections.
28
:
f
IMPiEDAUCE
SELECTOR
SW/TCH
..*
I’
Use to select the appropriate
.,...
. .
.,,
impedance of the speaker
enclosure(s). If two enclosures of
equal impedance are used, the
switch should be set at one half of
that value
(e.g.,two
16 ohm
enclosures: set switch to 8 ohms;
two 8 ohm enclosures: set switch
to 4 ohms).
PRE
POST
FOOTSWITCH
SELECT
RHYTHM
LOW MID HI
I
EFFECTS
BRIGHT1
1
CRUNCH
-
-
T
1
IMPEDANCE
SWITCH
OUTPUT
SIGNAL
FLOW BLOCK DIAGRAM
PREAMP
t
1
RESONANCE PRESENCE
5150 is a Registered Trademark of Edward Van
Halen