Filter
Top Products
7 of 7
ISSUED: 07-11-06 SHEET #: 055-9462-1
Secure projector cage (A) to top plates (B) using
four M5 x 10 mm penta pin screws (E). Tighten
screws using penta pin driver (F).
Insert pegs on one side of projector cage (A) into
slots of one top plate (B) and slide all the way to
last notch. Insert pegs on other side of projector
cage into slots of other top plate and slide over until
all pegs are resting on middle notches of slots.
3
Slide rods (D) into holes of projector cage (A). Use
as many rods as necessary to prevent projector
from being removed from projector cage.
Note: Position rods where projector lens will not be
obstructed.
2
D
A
3-1
© 2006 Peerless Industries, Inc. All rights reserved.
Peerless is a registered trademark of Peerless Industries, Inc.
All other brand and product names are trademarks or registered trademarks of their respective owners.
E
A
B
PEG
B
SLOT
A
Note: Padlock may be
used for added security.