Pelco C1959M Computer Monitor User Manual


 
4 Pelco Manual C1959M (6/99)
Table A. Video Coaxial Cable Requirements
Cable Type* Maximum Distance
RG59/U 750 ft (229 m)
RG6/U 1,000 ft (305 m)
RG11/U 1,500 ft (457 m)
*Minimum cable requirements:
75 ohms impedance
All-copper center conductor
All-copper braided shield with 95% braid coverage
3. Connect the equipment as shown in Figures 2 through 5. Refer to Table A for the type
of video coaxial cable to use.
4. Set the IMPEDANCE switch on the monitor(s) to HIGH if the VIDEO OUT connection
is used. Otherwise, set the switch(es) to the 75-OHM position.
5. Plug the appropriate power cord into the AC INLET connection on the rear panel of the
monitor (refer to Figure 2). Plug the other end into a power receptacle.
OUT
AUDIO
VIDEO
OUT
75 HIGH
IMPEDANCE
S-VHS IN
CAMERA
INPUT
IN
AC
INLET
S-VHS
JACK
AUDIO IN
JACK (RCA)
IMPEDANCE
SWITCH
(75/HIGH)
AUDIO OUT
JACK (RCA)
CAMERA INPUT
JACK (BNC)
VIDEO OUT
JACK (BNC)
IN
OUT
AUDIO
VIDEO
OUT
75 HIGH
IMPEDANCE
S-VHS IN
CAMERA
VCR
CAMERA
INPUT
IN
OUT
AUDIO
VIDEO
OUT
75 HIGH
IMPEDANCE
CAMERA
INPUT
IN
OUT
AUDIO
VIDEO
OUT
75 HIGH
IMPEDANCE
CAMERA
INPUT
IN
OUT
AUDIO
VIDEO
OUT
75 HIGH
IMPEDANCE
CAMERA
INPUT
CAMERA
VCR
MAXIMUM OF THREE MONITORS
Figure 2. Rear Panel Connections
Figure 3. One Monitor with External Video Equipment
Figure 4. Monitor Looping with External Video Equipment