Filter
Top Products
8 C4625M (9/09)
UDI Settings
LOCATING FIRMWARE VERSION INFORMATION
The following system information for the UDI5000-CAM software is located on the UDI Settings tab:
• Base Firmware Version: The version of software that was originally installed on the unit at the factory.
• Updated Firmware Version: The current version of the software, which represents the most recent software update.
Refer to this information when you contact Pelco Product Support.
CHANGING NETWORK SETTINGS FROM DHCP TO STATIC
The first time you connect the unit to your Endura network, the IP address is set automatically using Dynamic Host Configuration Protocol (DHCP).
If your system is set up to use static IP addresses, you can change it from the UDI Settings tab.
1. Locate the Network Settings section on the UDI Settings tab and select Static. The IP address, subnet mask, broadcast address, and
gateway address are deleted.
2. Enter the correct static information, and click Save.
Figure 4. UDI Settings Tab