Pelco C6825 Network Cables User Manual


  Open as PDF
of 4
 
DESCRIPTION
The C6806 and C6825 are prewired cables used to connect Pelco’s CX9024RX Coaxitron
®
receiver with Pelco’s PT680-24P pan/tilt. These
cables operate the pan/tilt in a noninverted mode.
MODELS
C6806 Six-foot (1.82 m) cable for use with PT680-24P, PT680-24SL pan/tilts and non-preset receivers (not for inverted operation)
C6825 Same as C6806 except 25-foot (7.62 m) cable length
INSTALLATION
1. Run the cable from the receiver to the pan/tilt. Be careful not to abrade or cut the jacket on the cable.
2. Connect the 37-pin CPC connector to the CX9024RX receiver.
3. Connect the 16-socket CPC connector to the PT680-24P pan/tilt.
4. Use a controller to test the following functions:
Pan Left
Pan Right
Tilt Up
Tilt Down
Zoom Wide
Zoom Tele
Iris Open
Iris Closed
Focus Near
Focus Far
If all the above functions operate correctly, the installation process is complete. If all the above functions do not operate correctly, refer to
Troubleshooting
.
SPECIFICATIONS
MECHANICAL
Connectors
Receiver Side: CPC, 37 pins
Pan/Tilt Side: CPC, 16 sockets
ELECTRICAL
Cable: 12 conductors with shield, 20 AWG
6 conductors with shield, 20 AWG
RG59/U
GENERAL
Dimensions
C6806: 6 ft (1.82 m) long
C6825: 25 ft (7.62 m) long
Maximum Wire
Temperature: 140°F (60°C)
 previous next