Filter
Top Products
C1632M-A (10/06) 9
Service
REPLACING A POWER SUPPLY
You can easily replace either of the two power supplies in the EPS5000-120 in case of failure. The power fail LED on the front of each power
supply turns red if there is a problem with the power supply. The blue Pelco badge will turn off if one of the power supplies fails. Before replacing
a power supply, check the fuse. It can be replaced easily with the supplied spare. If the fuse is not the problem, then follow these steps and refer
to Figure 5 to replace the power supply.
1. Unscrew both thumbscrews of the failed power supply.
2. Remove the power supply.
3. Insert the new power supply.
4. Secure the power supply by tightening both thumbscrews.
Figure 5.
Power Supply Replacement