Filter
Top Products
4 Pelco Manual C1007M-B (2/96)
Following is an explanation of the prompts:
REG: This is the electronic cash register (ECR)
number. If using an ICI3000P, an ECR’s number is
determined by the address assigned to it on the
ICI1000PIM installed at the register.
CAM: This is the camera number you wish to assign
to an ECR. The camera number is determined by its
video input on the ICI3008/ICI3016 switcher. When
cascading 8- or 16-position Inter-Check
®
switchers,
camera 8 or 16 will be the first video input of the
second switcher (refer to Fig.1). Each camera input
has a corresponding alarm output assigned to it on
the ICI3008/ICI3016 switchers. These alarm outputs
may be used in conjunction with the video inputs to
trigger peripheral devices. They may also be used
without video inputs to trigger pan/tilt presets on
PELCO matrix switchers.
DWL: The Dwell determines how long a selected
camera will remain on the monitor (in seconds) be-
fore switching to the next video camera. Entering
zero [0] for this value will cause the switcher to by-
pass the camera.
1. To edit this menu, press ENTER or press ESC to
return to the SYSTEM MENU.
2. Enter the register number you wish to select then
press ENTER.
3. Enter the camera number (or alarm output) you would
like assigned to this register followed by ENTER.
4. Select the dwell time for this camera in seconds or
zero [0] to bypass then press ENTER.
5. Repeat these steps until all selected registers have a
camera number and dwell time assigned to them.
This list will hold 32 thirty-two line items.
4.2 EDITING AN EXISTING
REGISTER LIST
To edit a camera list, press [ENTER].
Press [ESC] until the desired line is displayed. Enter the
appropriate data as described above.
Press [ESCAPE] until you reach the next line you wish
to edit or the end of the list.
Press [ENTER] to return to the SYSTEM MENU.
The Inter-Check
®
unit will display the previously pro-
grammed values when you re-edit the Shadow List. For
instance, if you wanted to change the dwell time of a
camera from 15 seconds to 10 seconds the following in-
formation would be displayed:
REG CAM DWL
8615 10
NOTE: Previously programmed values will
be deleted when you exit the shadow list.
5.0 OPERATION
5.1 CAMERA SEQUENCING
While in the monitoring mode, the Inter-Check
®
switcher
will sequence through the camera presets according to
the programmed dwell time assigned to each camera. To
stop camera sequencing, simply press the [S] button on
your keyboard. To resume switching, press the [S] key
again.
5.2 MANUAL REGISTER MONITORING
While in the monitoring mode, press [F1].
To display the transaction data on the LEFT side of the
monitor, press [1] one.
To display the transaction data on the RIGHT side of the
monitor, press [2] two.
Enter the register number to be monitored; then press
[ENTER].