Pelco WCSI-4 Power Supply User Manual


 
6 C561M-D (11/03)
OUTPUT WIRING
To install the output wiring to the camera, dome, or positioning system, refer to Figure 4 and do the
following:
1. Refer to Table A and determine the output connection needed for your camera, dome, or
positioning system. Refer to Figure 4, for the proper connector strip connections.
2. Attach one output wire to either the Tap A (24 VAC), Tap B (26 VAC), or Tap C (28 VAC)
connections on the Secondary Output Tap’s connector strip and attach the second wire to the
COM connection on the same strip. Be sure that you have the proper wiring size and distances
installed if you plan to change connections later.
3. Close the lid to the WCS1-4 power supply, replace the retaining screw to the door latch, and
then turn power on.
Primary Line Input
Line
Secondary Output Taps
COM
ABC
Neutral
100V
120V
230V
120V-1.6A, 250V
220V-0.5A, 250V
FUSE HOLDER
GROUND STUD
INPUT TERMINALS
SPARE FUSES
OUTPUT TERMINALS
Figure 4. Wiring Connector Diagram