Filter
Top Products
Introduction
12
RIP/X Requests
A Client may also request a route to a given network or server. To do so, the Client generates a Route Request
broadcast that the routers hear, and routers that know of the route requested will respond to the originating station.
In this way a new Client may find routes without waiting for the routers’ broadcast, that could be up to 30 seconds
away (if it just missed one). A new router on a network will also broadcast a general Route Request to fill its route
tables quickly. Again, without this mechanism the router would have to wait for about 30 seconds until it heard from
all other routers via their standard RIP/X broadcasts.
RIP/X Metrics
The RIP/X routing protocol measures routes based on two metrics, the hop count and the ticks delay. These metrics
are used to compare different routes to the same network, with the goal of selecting the best (shortest) route.
The ticks delay is the primary metric used to determine the optimal route. The tick count is an indicator of how long
a packet will take to get to the destination. Novell has defined 1 tick to be the length of time it takes a 512-byte
frame to be transmitted on a 10-Mbps (Ethernet) LAN. This works out to about 18 ms. The real value of the tick
delay is when evaluating routes across WAN connections. In these cases, the tick count is dependent on the link
speed of the WAN connection(s), where a slower link will have a higher tick count.
The hop count is the secondary measure of the length of a route; it is exactly the same as the IP hop count. If a route
goes through 1 router (the shortest route), it will have a hop count of 1. If a route goes through 6 routers, the hop
count for that route will be 6. The maximum number of hops RIP/X supports is 15, but this is a very large number,
considering the size of most internetworks. When two or more routes to the same network have the same tick count,
the router will use the route with the smallest hop count.
Bridging and the P2600 Router
The bridge portion of the P2600 Router is an Ethernet Media Access Control (MAC) level bridge providing an efficient
means of interconnecting IEEE 802.3 Local Area Networks supporting a choice of standard Ethernet (10Base5), Thin
Ethernet (10Base2) and Twisted Pair (10BaseT) interfaces. With the support of these industry-standard LAN interface
technologies, the P2600 Router will resolve the media conflicts that might have otherwise prevented the consolidation of
these resources.
The P2600 Router will also fit right into those environments that may require more than one bridge by using the IEEE
802.1D Spanning Tree Protocol. With this protocol, the P2600 Router will perform automatic network reconfiguration in the
event of a link failure to one of the LAN segments. This provides maximum availability of the attached LAN services.
Immediately following are several short descriptions of LAN bridging operations specific to the P2600 Router. These
descriptions will help you understand the concepts of bridging and how the P2600 Router performs these functions.
The remaining sections of this document describe how these functions are performed and configured. You are urged to
spend the small amount of time necessary to familiarize yourself with the P2600 Router and the advanced functions it may
perform for you.