Filter
Top Products
Perle S- 10G Media Converter Installation Guide
10
Operation
Powering up the Perle Media Converter
1. Connect the Perle supplied power adapter to the media
converter.
2. Turn on the power at the source.
3. Check that the PWR LED light is lit.
Status LED
The Perle 10G Media converters have three status LEDs located
on the front panel of the unit.
PWR - Power/Test
Green On: Power is on and the unit is in normal operation mode.
Green blinking slowly: the unit is in test or loopback mode.
Red blinking slowly while in Test mode: indicates an error
within the last second.
Red Solid: During power up - hardware error detected.
Red Blinking quickly: Error detected. (See LK1 LK2 Error
Codes).
Red (Solid or Blinking) – A module has been inserted that is
requesting more than the specified maximum power for that port.