Filter
Top Products
Perle 10/100/1000 Ethernet Extended Temperature Media Converter
Installation Guide
14
Method 1
1. Set the Link Mode to Standard on both media converters.
Leave all other switches in the Up position.
2. Connect the copper device to the copper port on the media
converter. The LKC LED light indicates good copper
connection. If the LKC LED is not lit, check the copper cable
and the attached device.
3. Repeat for the far end media converter.
4. Connect the fiber cable to both media converters. The LKF
LED indicates good fiber connection. If no LKF LED, check the
fiber cabling. Ensure the transmitter and receiver pairs are
crossed.
5. Return the units to the desired configuration. Connect the
power source to the Media converter.
Method 2:
The fiber connection can also be verified by configuring the remote
media converter for loopback mode. The LKF LEDs on both media
converters should be lit. Data should pass through the local
converter, over the fiber connection to the remote media
converter. At the remote media converter, the data will be looped
back and passed through the fiber, back to the local converter and
passed to the copper link.
Technical Specifications
Power Input / Consumption: 6-16V DC / 2.6 W at 12VDC
Operating Temperature:
-40°C to 75°C (-40°F to 167°F)
Storage Temperature:
-40°C to 85°C (-40°F to 185°F)
Operating Humidity: 5% to 90% non-condensing
Storage Humidity: 5% to 95% non-condensing
Operating Altitude: Up to 3,048 m (10,000 ft)
Dimensions: 150 mm by 95 mm by 26 mm
MTBF SC/ST Models: 489,616hours
MTBF SFP Models: 584,216hours