Filter
Top Products
CASTER MOUNTING
PLATE MUST
STRADDLE SEAM
CASTER MOUNTING
PLATE MUST
STRADDLE SEAM
COMPRESSOR
HOUSING
CENTER CASTERS
REQUIRED ON DC4KP
(4 KEG CONCESSIONAIRE)
DRY
STORAGE
COMPARTMENT
SCREWS
Form No. Z2283
Rev. 06.14.10
3
Perlick is committed to continuous improvement. Therefore, we reserve the right to change specifications without prior notice.
Preparing the Cabinet for Use – Concessionaire Dispensers
Parts List
■
Faucet Standard.
■
Faucet Head Assembly
■
Caster Set.
■
Black Connector Hose
3
⁄16” x 3’.
■
5
⁄16” Air Hose.
■
Spanner Wrench.
■
Bag of Miscellaneous Parts.
Tools Required
■
#2 Phillips Screwdriver.
■
Spanner Wrench (included).
■
#10 Crescent Wrench.
■
9
/16” Allen Wrench.
■
3
/8” Nut driver.
■
Power driver.
Uncrating and Inspection
Remove all crating material before operating.
Carefully inspect cabinet for hidden damage. If
damage is discovered, file your claim immediately
with the transportation company. Perlick is
not responsible for damage in transit.
Installing Casters
IMPORTANT: Attach casters to the cabinet bot-
tom so that caster is centered over cabinet seam.
Use supplied
1
/4”- 20 x
3
/4” hex head self-tapping
machine screws.
Plumbing
Connect drain tube from drainer into dump tank.
Electrical
The cabinet must be connected to a separately
fused power source (see electrical specification
plate) and grounded in accordance with National
and Local Electrical Codes. Caution: Do not
attempt to operate the equipment on any other
power source than that listed on the Electrical
Specification plate.
Installing the Faucet and
Dispensing Head
Before you begin: Wash dispensing head and fau-
cet. Flush beer, dispensing head and faucet lines
with fresh water.
■
Apply RTV around the base of the dispensing
head to seal it to the top. Align the dispensing
head over the five holes on the cabinet top
and use the five stainless steel #10-32 x 1
3
⁄4”
Phillips pan head stainless steel machine
screws to secure standard to cabinet top.
Wipe off excess RTV to complete the seal.
■
Attach faucet to standard using spanner
wrench to tighten coupling. Attach faucet
handle to faucet.
■
Insert flexible plastic air hose six to seven
inches into bottom of faucet standard.
Secure hose with tie wrap (supplied).
DUMP TANK
CO2 TANK
A
CCESS DOOR
CHAIN FOR
SECURING
CO2 TANK
CABINET
ACCESS
HOLE
DRAIN TUBE
FROM
DRAINER
REMOVABLE
DUMP TANK
CO2 TANK
(Must Be Secured
When Moving
Cabinet)