Filter
Top Products
21
> A number display shows from 1~100 the percentage of memory storage progress from the
Wireless Smart-Loader to the TV (100 = fully loaded).
SMARTLOADER TO TV |||-------- ##
> When data transfer is completed, ## is “100”, the following menu appears for 3 seconds:
TV READY >
> After that, the following menu comes up
GOODBYE >
> The TV goes to standby now and your TV is installed and ready for start-up and use.
Problem Solution
The message “WRONG VERSION” is
displayed on the screen.
The program stored into the Wireless Smart-Loader has a
software code incompatible with the actual TV.
Reprogram the Wireless Smart-Loader from a master TV
whose software code is compatible with the actual TV.
TV doesn’t respond to the Wireless Smart-
Loader.
-check if the LED on the Wireless Smart-Loader is green when
pressing any button and check if the batteries are in a good
condition. Replace batteries if necessary.
- try to bring the Wireless Smart-Loader more closer to the
TV infra red receiver and try again.
Tips:
1. Do not forget to write the software code and the type of relevant master TV on the sticker used on the back
of the Wireless Smart-Loader.
2. The Wireless Smart-Loader can retain without batteries, the stored information for ten years if required.
Note:
Before putting the Wireless Smart-Loader into store for a long time, make sure that the batteries are all taken
out to prevent the batteries corroding the contacts.
Problems and Solutions:
Press the OK key for approximately 5 seconds. The following text then appears:
SERVICE
1 REMOTE BATTERY OK
If the word “LOW” appears instead of “OK”, the remote control batteries are low and must be replaced.
Low battery check