Resetting the projector
1 Press the Standby button twice in succession to switch the projector into the Power/Standby
mode.
2 Wait until the cooling fan has stopped (about 3 minutes after the projector has been
switched to Power/Standby).Then disconnect the mains lead to switch off the mains supply.
3 Connect the mains lead again and press the Standby button to switch the projector back
into Power/Standby mode.
– The Standby indicator lights up red, the projector is now in the Power/Standby mode.
4 Press any button on projector or remote control to switch on the projector.
– The Standby indicator lights up orange.
– When the projection lamp is on, the Standby indicator lights up green and your personal
start-up screen appears.
Your personal start-up screen will appear each time the projector is switched on exept when the
SecurityMax
™ application has been activated.The
SecurityMax
™ start-up screen will then appear.
Note
Philips Multimedia Projector 27 English User guide bSure1 / bSure 2
5. Operation On Screen Display Menu <
Menu OK
AV
Mute
Source
Stand
by
Lamp
Temp
Menu OK
AV
Mute
Source
Stand
by
Lamp
Temp