Filter
Top Products
>
If a fault occurs, first check the points listed below before taking the projector for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or service
organisation.
Under no circumstances should you try to repair the projector yourself as this could invalidate the
guarantee.
– Possible cause
• Solution
General
– Mains lead is not correctly connected.
• Correctly connect mains lead.
– The filter holder is not installed correctly or is damaged.
• Install the filter holder correctly (see ‘Cleaning the dust filter’ under ‘Maintenance’).
– Lamp holder cover is not closed correctly or the lamp holder is damaged.
• Close the cover correctly (see ‘Lamp replacement’ under ‘Maintenance’).
– Signal cable not correctly connected.
• Connect signal cable correctly.
– The projector is in Off position.
• Press Standby to switch on the projector.
– A/V Mute active.
• Cancel A/V Mute.
–‘Shift’ and/or ‘Horizontal size’ are not adjusted correctly.
• Adjust ‘Shift’ or ‘Horizontal size’ (see ’Display adjustment’ under
‘Operation’ - ‘On Screen Display Menu’).
• Activate the ‘Auto-image’ function via the On Screen Display menu.
In Component Video mode
–‘Auto Image’ has not selected the correct settings for ‘Shift’ and/or ‘Horizontal Size’.
• Adjust ‘Shift’ or ‘Horizontal size’ (see ’Display adjustment’ under
‘Operation’ - ‘On Screen Display Menu’).
• Activate the ‘Auto-image’ function via the On Screen Display menu.
• Reset all settings to the default factory settings with the ‘Factory reset’ option in the
‘Settings’ menu.
– Keystoning is applied on a high resolution component signal.
• Decrease keystoning until the image is correctly displayed. For this use the the ‘Keystone
correction’ option in the ‘Settings’ menu.
Warning
Read as follows
Problem
Image is not or incorrectly
displayed
Philips Home Cinema Projector English User guide Garbo 30
7.Troubleshooting