Filter
Top Products
2.2 Programming
Programming Guide 35
Note
If the gateway entry is registered to a DN2IP entry (see "2.2.7 Address Translation
Table—DN2IP Entry"), no check box will be shown for the gateway entry.
b. Click DELETE.
• Click LOGOUT to log out from the IP-GW16 Maintenance Utility (see "2.5.2 Log Out").
4. Click ENTRY.
A maximum of 512 gateway entries can be created.
5. Click OK.
You will see a confirmation screen.
Note
If your entry contains an invalid value, you will be prompted to correct your input. Enter
correct values for the parameters shown in red and try again.
6. Confirm your entry and click OK.
To return to the previous screen, click CANCEL.
Parameter Descriptions
The parameters indicated with "*" must be changed while the VoIP Gateway Card is in the "STOP" status (see
"2.3.1 Status Control"). The changes do not have to be followed by a reboot to become effective.
GW Entry
The parameters below are used to create gateway entries for both local and remote cards on the network, as
a preliminary step to programming the address translation table (DN2IP).
For a programming example, refer to "3.2.5 Programming the Address Translation Table" of the VoIP Gateway
Card Getting Started.
Note
If you are using a gatekeeper, create the gateway entry only for the local card.
Parameter & Description Default Value Range
*
GW No.
Specifies the number for the gateway entry to be created.
When changing the current settings of an existing gateway
entry, first delete the gateway entry and then re-create with
new values.
0 0 to 511
*
Comment
Specifies the comment for the gateway entry.
No default Max. 16 characters
*
IP Address
Specifies the IP address of the card.
No default The following addresses
are invalid:
• Class D addresses
• Class E addresses
• Loopback
addresses