Filter
Top Products
Initial Operation 9
3 Initial Operation
Setting up the Device
You can position the device so that it lies at on a table
in front of the projection surface; it is not necessary to
tilt it towards the projection surface. The device com-
pensates for the distortion from the slanted projection
(pincushion distortion).
A tripod accessory is available if you want to elevate the
device (Pico Tripod / 253521272).
Connecting power supply /
Charging battery
1 Insert the small plug of the power supply into the
socket on the rear side of your device.
2 Plug the power supply into the power outlet.
3 During the charging process, the indicator light on
the side of the device will be red. When the battery
is fully charged, i
t will turn green.
4 Charge the built-in battery before using for the rst
time for at least 3 hours. This will prolong the life of
the battery.
Initial Installation
1 Switch the device on using the on/off switch on the
side.
2 Turn the device towards a suitable projection sur-
face or wall. Note that the distance to the projection
surface must be a minimum of 0.5 meters and a max-
imum of 5 meters. Make sure the projector is in a
secure position.
3 Use the focus wheel on the top to adjust the image
sharpness.
4 Select the desired menu language using
.
5 Conrm with à.
CAUTION!
Electrical Voltage at the Site of Installa-
tion!
Check whether the electrical voltage of the
power supply matches the electrical voltage
available at the setup location.
Note
The main menu appears instead of
the language selection
The device has already been installed. In
order to change the menu language, pro-
ceed as follows:
1 Use the navigation keys to select Set-
tings.
2 Conrm with à.
3 Select with Language.
4 Conrm with à.
5 Select the desired language with
.
6 Conrm with à.
7 Exit with .