Filter
Top Products
Appendix
Technical Information
ENGLISH - 48
J Cable specifications
(When connected to a personal computer)
J Control commands
You can switch the signals which to output from the COMPUTER1 OUT terminal by pressing the computer key
command. The key commands are depend on the manufactures. If you select the computer terminals which has no
signals while the INPUT GUIDE is set to DETAILED, the computer connection guidance will be displayed.
Command Control contents Remarks
PON Power ON
In standby mode, all commands other than the PON command are
ignored.
The PON command is ignored during lamp ON control.
POF Power OFF
If a PON command is received while the cooling fan is operating after the
lamp has switched off, the lamp is not turned back on again straight away
in order to protect the lamp.
AVL Volume
Parameter
000 - 063 (Adjustment value 0 - 63)
IIS INPUT
Parameter:
VID = VIDEO
RG1 = COMPUTER1
SVD = S-VIDEO
RG2 = COMPUTER2
NWP = WIRELESS (PT-F100NTE only)
Q$S
Lamp condition
query
Call back
0 = Standby
1 = Lamp ON control active
2 = Lamp ON
3 = Lamp OFF control active
OSH SHUTTER
Turning off the projection temporarily.
Send the command to switch between ON and OFF.
Do not send the command consecutively.
Computer connection guidance
Manufacturer Key command Manufacturer Key command Manufacturer Key command
Panasonic
NEC
+
TOSHIBA
SHARP
HP
+
IBM
SONY
+
Apple
FUJITSU
+
EPSON
DELL
+
Other
+
NOTE:
• The computer connection guidance will disappear after 5 minutes.
• Please refer the instructions which provided with the computers for more detailed information.
NC
NC
NC
NC
NC
NC
NC
NC
Projector PC (DTE)