Filter
Top Products
6
The units should now be connected to the telephone. Once
steps 1-5 have been completed in the installation sequence
above, you can now set the security, programming the base
unit to the extension unit.
Follow the easy steps below to set the security feature for
the units.
1. Using a small pointed object,
press the black recessed
button on the side of the
base unit. The green light on
the front of the base unit will
come on. This will stay lit
during the security programming
sequence.
2. Now, using the same small pointed object, press the black
recessed button on the side of the extension unit. The
green light on the front of the
extension unit will flash once.
This is your notification that
the security programming for
this extension is complete.
To program additional
extensions to the same base, repeat
step 2 with the additional extensions. This programming
sequence allows five minutes since the last unit was
programmed, to program the next unit.
Note: If the green light is flashing repeatedly, your base unit
is not in programming mode. You will need to return to
step one and repeat the steps.
3. Once all extensions have been programmed, you will
need to verify the dial tone for each phone. This can
easily be completed by picking up the handset and
listening for dial tone.
Base Unit
Green Light
Extension Unit
Green Light
Security Programming