Filter
Top Products
42
(2) Assembling the System
The basic procedure for assembling the system is as follows.
1 Assemble the projection stand (RM-V112/RMA-V5010).
2 Mount a one-link mount unit . (40-inch only)
3 Assemble the projection frame (RMF-V4011/V5011).
4 Mount the multi-projection unit (RM-V4000V/V5000V).
5 Mount the projection screen kit (RMS-V4011/V5011).
6 Mount the top board , side board , rear panel.
The basic procedure for assembling the system for rental-use is as follows.
1 Assemble the projection stand (RM-V112).
2 Mount the 2-link/3-link mount unit (RMA-V2050/V2060).
3' Mount the multi-projection unit (RM-V4000V) to the projection cabinet (RMF-V4011R).
4' Mount the projection cabinet (RMF-V4011R).
The above procedure is recommended. It is explained below.
1 Projection Install Tables (RM-V112/RMA-V5010)
Place the installation tables (RM-V112) at the specified position and link them together with the bolts and nuts specified.
First tighten the bolts and nuts temporarily, and after all have been linked, check their height differences and if they are
horizontal before tightening the nuts and bolts firmly.
Do not tighten the adjusters at the legs as their final positions have to be adjusted after assembling all units.
To install at a height greater than the installation table when not using this table, make sure the strength is greater than
required.
2 Mount Unit (RMA-V2050/V2060)
Place the mount unit on the stand and join them using the specified bolts and nuts.
As the horizontality, difference in level, etc. of the mount units form the basis of the whole system assembled, assemble them
accurately.
If gaps are formed between the mount unit and the stand due to the difference in height, use the floor leveler of the stand to
adjust the height, or place spacers between the mount unit and stand (metal plates about 1 to 2 mm thick).
When using several mount units, adjust their height, horizontality, etc.
In the case of the system for rental-use, mount the conventional mount units (RMA-V2050/V2060) using the conventional
method. For details, refer to the RM-V2000A technical manual.
INSTALLATION AND ASSEMBLY