Filter
Top Products
58
(3) White Balance Adjustment Memory
ADJUSTMENTS has altogether six white balance adjustment memories.
VIDEO, Y/C input memory
RGB input memory
Factory shipment memory
Four memories can be actually adjusted except the factory shipment memory. The factory shipment memory contains the
normal white balance adjustment data and re-expose white balance adjustment data.
By setting to color mode 1 using the rear panel switch, etc., the white balance adjustment data can be switched by synchroniz-
ing with input switching. This is the same for color mode 2. If it is necessary to change color modes 1 and 2 using the input
function, connect the PC and switch each time it is necessary.
Color mode 2 (Re-expose)
VIDEO, Y/C input memory
RGB input memory
Factory shipment memory
Color mode 1 (Normal)
(4) Combined Use of Remote Control and Personal Computer
Although it is possible to connect both the remote control (RU-V107) and Personal Computer, adjustments cannot be per-
formed using both at the same time.
Remote control, Personal Computer commands and rear panel switches operated the latest are given priority. When the
adjustment mode is set by the Personal Computer while adjusting with the remote control, the adjustment mode will be set by
the Personal Computer, disabling adjustments to be performed using the remote control. If the adjustment mode is set by the
remote control using adjustments by the Personal Computer, adjustments by the Personal Computer will be disabled. Fur-
thermore, if the rear panel switches are operated when the adjustment mode is set by the remote control or Personal Com-
puter, the adjustment mode is exited and the rear panel switches operations are started.
(5) Memory of Adjustment Data and Settings
When adjustments are ended in the adjustment mode such as convergence, white balance, etc., always exit the adjustment
mode (AJN for Personal Computer, ADJ OUT key for remote control). If the power is turned off (AC OFF) without exiting the
adjustment mode, a part of the adjustment data will not be preserved in the memory.
The input function, MULTI ON/OFF (peripheral light amount switching), COMBINATION ON/OFF (ABL link switching), COLOR
MODE 1/2 (white balance switching), TV SYSTEM setting, and convergence memory state setting will be preserved in the
memory only when the power is turned off using the remote control, command of a Personal Computer (POF) or the rear
panel tact switch. The AC ON/OFF will not allow data to be preserved in the memory.)
When starting or stopping the system by AC ON/OFF in an installation condition for demonstration, use this method to
preserve the conditions in the memory first.
ADJUSTMENTS