Filter
Top Products
8
All rights reserved. No part of this document may be reproduced or transmitted in any form or by any means, electronic or mechanical
(including photocopying, recording, or by any information storage retrieval system), without the owner’s express written permission.
AW20905 Rev. A
Checking Connectivity
To check connectivity, you may perform a balance inquiry by following the steps below:
DM500 through DM1000 DM300c through DM450c
1. Verify the Network Adapter LED is
On or flickering
1. Verify the Network Adapter LED is On or flickering
2. Press the Funds key 2. Press the Refill Postage key
3. Choose Get Postage by Phone®
Balance
3. Choose Check PBP Balance
4. The following should occur in quick
succession
4. The following should occur in quick succession
a. Display of Requesting
Balance
a. Display of Requesting Balance
b. Display of Processing b. Display of Processing
c. Display of Actual Balances c. Display of Actual Balances
5. Press Done to Exit 5. Press Continue to Exit
If an error message is delivered, please review these Set Up instructions again with regards to the meter,
and check the firewall parameter settings before continuing.
Service Support
Service Support on LAN connectivity can be obtained by calling 1.800.522.0020