Filter
Top Products
SD2020 | 7 | User's Guide
Connect the cables
The SD2020 unit comes with one 6-foot DVI cable, one 12-foot DVI cable, and
one 14-inch DVI cable.
1. Plug one end of the 6-foot DVI
cable into the primary port of
the dual-channel DVI graphics
card. Plug the other end into
the bottom monitor of the
SD2020 unit.
2. Plug one end of the 14-inch DVI
cable into the secondary output
of the dual-channel graphics
card. Plug the other end into
the input port (labeled “IN”) of
the mirror-flip PCI card.
3. Plug one end of the 12-foot DVI
cable into the output port of the
mirror-flip PCI card (labeled “OUT”).
Plug the other end into the top
monitor of the SD2020 unit.
The two monitors must be connected with an off-the-shelf video
cable to comply with FCC regulations. Ferrite-core interface
cables are provided. This device will not be in compliance with
FCC regulations when a non-ferrite-core video cable is used.
Short DVI cable installed.