Filter
Top Products
Chapter 2 Using ADE-4200/ADW-4200
7
ADSL
Connect the supplied RJ-11 cable to this port when
connecting to the ADSL/telephone network.
Console
Connect a PS2 or DB9 RS-232 cable to this port
when connecting to a PC’s RS-232 port (9-pin serial
port). Please note that console cable is not
provided on standard package.
LAN 1 — 4
(RJ-45
connector)
Connect an UTP Ethernet cable to one of the four
LAN ports when connecting to a PC or an
office/home network of 10Mbps or 100Mbps.
Reset
After the device is powered on, press it to reset the
device or restore to factory default settings.
The operation is as below:
0-3 seconds: reset the device
3-6 seconds: no action
6 seconds or above: restore to factory default
settings (this is used when you can not login to the
router, e.g. forgot the password)
PWR
Connect the supplied power adapter to this jack.
Power Switch
Power ON/OFF switch
2.4 Cabling
The most common problem is bad cabling or ADSL line. Make sure that all connected
devices are turned on. On the front of the product is a bank of LEDs. As a first check,
verify that the LAN Link and ADSL line LEDs are lit. If they are not, verify that you are
using the proper cables.