Filter
Top Products
Step3Î Check the TV display. The default display of Digital Media Center is
Composite (CVBS). If you use HDMI, aim the remote control at the Digital
Media Center and push “ ” Key. You can cycle through the TV modes
to get the correct display.
Step4Î Wait few seconds for the startup page to show up, and it will turns
into the Main Menu Afterwards.
Step5Î The startup page will last for only few seconds, and then go to a
black screen. Please wait few seconds and it will run into the Main Menu. If
there is no video output after the startup page appears, please make sure the
Digital Media Center and the TV are in the same mode.
If not, please cycle through the “ ” key on the remote control, wait few
seconds during each cycle.
"Note
When you cycle through the “ ” Key, the Digital Media Center
will tell you which mode you are at. Below figure is an example of
cycling to “HDMI” mode. Please press “OK” if you want to select to
HDMI mode. It will switch to the ori
g
inal mode automatically if idle
for 15 seconds.
20