Filter
Top Products
14
15
Chapter 4
Troubleshooting
This chapter contains information to help you solve problems. If the Switch is not
functioning properly, make sure the Switch was set up according to instructions in this
manual.
The Link LED is not Lit
Solution:
Make sure the switch conguration is consistent with the connecting device
Check the cable connections.
Performance is bad
Solution:
Check the full duplex status of the Ethernet Switch. If the Ethernet Switch is set to full
duplex and the partner is set to half duplex, then the performance will be poor.
Some stations can not talk to other stations located on the other port
Solution:
The address table may contain older information than of the address table of that node.
Please power down to refresh the address information.