Filter
Top Products
27
3. External Microphone
Connect a microphone to the IP camera.
4. SD Card Slot
User can insert a micro SD card into this slot for event recording.
5. RJ-45 LAN Socket
The LAN socket is a RJ-45 connector for connections to 10/100Base-TX
Fast Ethernet cabling. This Ethernet port built N-Way protocol can
detect or negotiate the transmission speed of the network automatically.
Please use CAT-5 cable to connect the IP camera to a 100Mbps Fast
Ethernet network switch or hub.
6. Factory Default Reset
This button is used to restore the all factory default settings.
Sometimes restarting the device will make the system back to a normal
state. However, if the system still got problems after restart, user can
restore the factory default settings and install it again.
Restore the device:
a. Insert the paper clip or other tool and press and hold the button
down continuously.
b. Hold it at least 5 seconds and release the tool. Then the device has
been restored to default settings and reboot again.
7. DI/DO Connector
The Camera provides a terminal block with 4 pins of connectors for DI
and DO. Please refer to the user’s manual for more information. The
pin 1 is located at the right side of terminal block from rear view.
2.7.3 ICA-H610 Installation
Ceiling Mount
1. Fix the IP camera to L-type bracket with the two supplied screws.