Filter
Top Products
23
Figure 3-3: Connecting Multiple PCs to an Ethernet LAN
Note
Please refer to your Ethernet device User’s
Manual for the device’s set up information.
3.3 Connecting VC-202
3.3.1 Connecting Standalone IP device
Refer to the following procedures to setup the VC-202 to a
standalone PC.
1. Set the VC-202 to be CO mode or CPE mode from the
DIP switch at the rear panel.
2. Power on the VC-202 by connecting its power source.
3. Power LED will illuminate.
4. Connect coaxial cable from another VDSL device to VDSL
BNC port of the VC-202.