Filter
Top Products
Hardware Installation Plasmon AA Express User Manual
Page 16 Document Revision B
3. Attach two of the L brackets to the ends of the fixed rails that have four mounting holes
using four of the short M4, 6mm x 16 screws, as shown below. Repeat for the other rail.
Choose either the long L brackets, or the short L brackets, depending on the depth of the
rack. These brackets can be mounted with the L end facing either forward or to the back
to provide maximum adaptability. Try different combinations to fit the rack.
4. Attach the assembled fixed rails to the mounting rails in the rack using the threaded
backing plates. Place a plate with the smaller holes on the inside of the mounting rail, and
a plate with the larger holes on the outside of the mounting rail at the appropriate height
using three M4, 12mm x 20 screws for each pair of brackets as shown below.
5. Slide the AAE enclosure fully into the rack by fitting the sliding rail into the fixed rail on
each side. The stop latch on each side engages to prevent unintentional removal.
Threaded Backing Plate
(with small holes)
Threaded Backing Plate
(with large holes)
L Bracket fits between rear
backing plate and rack rail,
straddling center screw