Filter
Top Products
7
97705183 A
User Manual
Additional Notes for Internal Models
✗ Never connect / disconnect unit to / from SCSI bus with
power on any units including host computer.
✓ When handling the unit, an anti-static wrist strap should be
used to avoid possible damage from static electricity.
✓ Ensure that the power connector is correctly wired.
✓ Check that the power is within the unit’s specification.
✓ Ensure that adequate ventilation is provided.
GETTING STARTED
Operation & Installation Instructions
External Drive
Do not apply power yet!
Set the SCSI ID of the unit via the DIP switch on the rear of the unit.
(see Appendix B and C)
Connect the SCSI interface cable between the computer and the drive
unit.
If the drive is the last unit on the SCSI interface, install the supplied
terminator in the unused SCSI connector.
Apply power to the unit.
Insert a disk cartridge into the drive, gently pushing it into the drive until
it is power loaded. The motor will start and after a few seconds the drive
will be ready for use.
When the eject button is pressed the cartridge will electronically eject
from the drive after a short delay.