PLUS Vision U7-132/U7-137 Projector User Manual


 
E-49
View
Perform this operation while projecting the picture for which the adjustment/setting will be made.
Select the menu name View.
See “Menu Operation Method” on Page E-37 for information about performing menu operations. The item name display will
differ depending on the input signal. See “List of Item Names Offering Input Selection and Adjustments/Settings” on Page E-42.
This function sets the horizontal and vertical picture proportions of the
input signal.
Select the item name “Aspect” and select the setting contents with the SE-
LECT (̇̈) buttons.
Video Signals
Auto ............ While maintaining the aspect ratio, projects a full screen
so that no portions extend beyond the boundaries of the
screen. The top and bottom of the 16:9 image becomes
black.
Wide ........... Projects to fill the full width with the entire image at 16:9.
(This feature is used to project a squeezed image in a
proper aspect ratio.)
Zoom .......... Projects only the 4:3 portion within 16:9 image to fill the
screen. (Portion that extend off screen is cut.)
Aspect ratio selection Auto Wide Zoom
4:3 screen
16:9 screen
Personal Computer Signal
Auto............ Automatically enlarges or reduces the image to project
a full screen in a ratio of 4:3
Direct.......... Maintains the aspect ratio and projects a picture of the
maximum displayable size
Real ............ Projects the input signal without pixel conversion
Input Signal Auto Direct Real
The setting is higher
than the display reso-
lution of the projector.
The setting is lower
than the display reso-
lution of the projector.
Note:
Please note that using this monitor for the purpose of commercial gain or the attraction of public attention in a venue such as a coffee shop
or hotel and projecting a 4:3 screen in wide mode or leaving a squeezed screen as a compressed image raises concern about the infringement
of the copyright holders rights which are protected by copyright law.
Note:
When selection has been made for the Real setting of the personal computer signal (i.e., when the input signal and the projector display
resolution are high) and the Zoom setting of the video signal, pressing the SELECT (
̆̄̇̈
) buttons on the remote control will permit
movement of the display position. Note that there will not be any movement when the menu or the quick menu is displayed.
The Real setting under Aspect for digital RGB signals can only be adjusted when the input signal is of XGA size or smaller.
Aspect
Filter
This function sets the sharpness when the input signal is adjusted to
the resolution of the projector and enlarged or reduced.
Select the item name “Filter” and select the setting contents with the SELECT
(̇̈) buttons.
Smaller numerical values result in a sharper picture and larger values result in
a softer picture. Please select your desired setting value.