PLUS Vision U7-132/U7-137 Projector User Manual


 
E-59
Troubleshooting
Check the following matters before requesting servicing.
Is the power cord plugged into a power outlet?
Is the lamp cover properly mounted?
Is the projector’s temperature high? To protect the projector, the power can-
not be turned on when the projector’s temperature is abnormally high.
Has the lamp reached the end of its service life?
Depending on the timing with which the power cord is plugged in (the power
is turned on), it may happen that the STANDBY indicator (LED) does not
light and the power does not turn on. This is not a malfunction. If this hap-
pens, unplug the power cord then plug it back in.
Is a connected input selected?
Is the cable properly connected to the input terminal?
When a computer is connected, are signals being output from the computer?
Does the signal being input have a frequency usable with this projector?
Are the brightness and contrast adjusted to the minimum?
Is the STATUS indicator lit a steady red or blinking red?
When the component signal of the DVD player is connected with the DVI or
RGB connector and the image is not output, is [Input Settings] of the DVI or
RGB connector properly selected?
For a analog RGB or DVI analog input, has the picture been properly adjusted?
Is the projector properly installed?
For trapezoidal (keystone) distortion, perform keystone adjustment.
Is the lens properly focused?
Are the screen and projector installed at the proper distance?
Does the projection distance exceed the focusing range?
Is there condensation on the lens, etc.?
If the projector is moved from a cool storage area to a warm place and the
power is turned on, condensation may form on the lens or internal optical
parts. If this happens, wait until the condensation has evaporated before
using the projector.
For a computer input, are the horizontal and vertical positions properly ad-
justed?
Does the input signal have a compatible resolution and frequency? Check
the computer’s resolution.
If the image is crushed in the horizontal or vertical direction or if it is not
displayed over the entire screen, select a different aspect ratio.
When inputting component signals (HDTV signals only), is “Color Space”
setting correct?
For a composite input, is “Tint” properly adjusted?
From the menu, select “Image” and adjust the “Picture Adj.” and “Fine Picture”.
Other than [Setup], [Option] and [Info], selection will not be possible unless
a signal is being input to the projector and the image/picture is projected.
Are the remote control unit’s batteries worn? Replace with new batteries.
Is there an obstacle between the remote control unit and the projector’s
remote control signal sensor?
Is the remote control unit outside of range?
Are you pointing the remote control unit’s transmitter towards the projector’s
remote control signal sensor?
See “When an indicator is lit or blinking”.
Power does not turn on
No image is produced
Image is distorted
Image is out of focus
Image is not in proper posi-
tion and is not displayed
properly
Video image is crushed
Colors of the overall image
are strange
Characters flicker or colors
are offset for analog RGB
inputs
Cannot select the menu
name
Remote control unit does
not operate
STATUS indicator is lit red
or blinking red
Problem
Check
Reference
Page
E-22
E-63
E-58
E-58
E-52
E-15–21
E-17
E-65
E-44
E-58
E-52
E-44, 45
E-25
E-50
E-26
E-14
E-14
E-45
E-65
E-49
E-47
E-44
E-44, 45
E-12
E-12
E-12
E-12
E-58