Filter
Top Products
Avaya AP-6, AP-7, AP-8 Access Points
PN: 1725-36046-001_G.doc
5
Access Point Configuration
(Up to Version 2.4.11)
1. Connect to the AP via Netscape or Internet Explorer by navigating
to the URL http://<IP_Addr> (where <IP_Addr> is the IP
address of the AP).
2. Note: these configuration steps can also be accomplished using
the SNMP-based Avaya ScanTool program.
3. From the main page, click on the
Configure link.
4. To configure WEP settings, obtain the key values from the local
network administrator and use the Avaya AP-6, AP-7, or AP-8
User Guide for guidance in programming the encryption settings.
The WEP configuration screen is reached from the main menu by
clicking on
Configure, followed by Security, followed by Encryption &
Auth
.
Note that the handsets must each be configured manually with
the identical WEP settings.
5. Click
Configure, then click the Interfaces link and choose the
appropriate radio (
Slot A or Slot B) to configure.
6. From the
Interfaces tab, confirm that the RTS/CTS Medium Reservation
Threshold is greater than 600 or disabled.
7. Set the
Transmit Rate field to 11Mb/s.
8. From the
Filtering tab, select the Advanced tab. Enable the Proxy ARP
function and disable
IP/ARP Filtering.
9. The SpectraLink 8000 SVP Server is disabled by default in the
ORiNOCO AP-600/AP-4000 access point and must be enabled
through the command line interface (CLI). The CLI is available
through both the serial port interface and over the Ethernet
interface using a Telnet session.
10. Once in the CLI, the following commands are used to enable SVP:
a. To check to see if SVP is enabled:
Type
show spectralink, then press Enter; it will display
enabled or disabled.
b. To enable SVP:
Type
set speclinkstatus enable, then press Enter.