Filter
Top Products
Avaya AP-6, AP-7, AP-8 Access Points
PN: 1725-36046-001_G.doc
7
Access Point Configuration
(Version 2.52)
1. Connect to the AP via Netscape or Internet Explorer by navigating
to the URL http://<IP_Addr> (where <IP_Addr> is the IP
address of the AP).
2. From the main page, click on the
Configure link.
3. To configure WEP settings, obtain the key values from the local
network administrator and use the Avaya AP-6, AP-7, or AP-8
User Guide for guidance in programming the encryption settings.
The WEP configuration screen is reached from the main menu by
clicking on
Configure, followed by SSID/VLAN/Security, followed by
Security Profile
Note that the handsets must each be configured manually with
the identical WEP settings.
4. Click
Configure, then click the Interfaces link and choose the
appropriate radio (
Slot A or Slot B) to configure.
5. From the
Interfaces tab, confirm that the RTS/CTS Medium Reservation
Threshold is greater than 600 or disabled.
6. Set the
Transmit Rate field to 11Mb/s.
7. From the
Filtering tab, select the Advanced tab. Enable the Proxy ARP
function and disable
IP/ARP Filtering.
8. The SpectraLink 8000 SVP Server is disabled by default in the
Avaya AP-6, AP-7, and AP-8 access points. To enable SVP, select
the
QoS tab. Select the Enable Quality of Service check box to enable
SVP.
9. Conditional: If you are not using a SpectraLink 8000 SVP Server
and intend to use 802.11b/g mode, it is necessary to use the
command line interface (CLI). The CLI is available through both
the serial port interface and over the Ethernet interface using a
Telnet session.
a. Once in the CLI, enter:
set speclinklegacysupport enable
b.
To ensure that SpectraLink legacy support is enabled, enter:
show speclinklegacysupport