Filter
Top Products
Chapter 1- Hardware Description
1-32
5 On the CNTL Module to be installed, move the ejector lever to the
fully open position.
6 Slide in the replacement
CNTL Module.
7 Push the
CNTL Module firmly into the Backplane, making sure it is
properly seated in its slot.
8 Ensure that the metal ejector levers are fully retracted into their
housings.
9 Tighten the captive screws on the front panel of the RMX 2000 that
secure the Functional
CNTL Module.
10 Turn ON the RMX 2000.
For more information on the Card Configuration Modes after reset, see "MPM/
MPM+ and MPMx Configuration Modes” on page 1-22.