Polycom DOC2559B Server User Manual


 
Polycom RMX 4000 Hardware Guide
1-7
MCU Card Configuration Mode Guidelines
MPMx and MPM+ Modes
MPMx and MPM+ cards installed in the system cannot be used
simultaneously. Therefore, the RMX can operate in either MPM+ or
MPMx Card Configuration Mode.
MPMx Mode is the mode in which the RMX operates to fully utilize
the increased power and capacity of MPMx cards.
ISDN support is the same as for both MPM+/MPMx cards.
G.719 audio algorithm is not supported with MPMx.
Card Configuration Mode Selection During Startup /
Restart
When the MCU is started with Version 7.0.x installed and no media cards,
the RMX is set to MPMx Card Configuration Mode by default.
The RMX switches between MPMx and MPM+ Card Configuration Modes
when MPM+/MPMx cards are removed or swapped while the system is
running.
The switch between Card Configuration Modes occurs during the next
restart.
Installing or swapping MPM+/MPMx cards while the system is off will not
cause a switch in the Card Configuration Mode when the system is restarted
– it will restart in the Card Configuration Mode that was active previous to
powering down.