Filter
Top Products
Part 3
be supplied through the interface cable from the main unit and just
connect the video interface cable. Connect the other end of VGA cable
to the appropriate VGA port. The monitor will always turn ON
whenever power is made available.
5. Adjust for best viewing tilt angle and engage the on screen display
(OSD) adjustment for best display effect whenever necessary. The
monitor will sign for “No Signal” status and go into power saving mode
in 5 seconds when there is no video signal. The display will come back
when the signal does.
V. OSD
A. OSD buttons
“OSD” button: To enter OSD setup menu, or to perform function selected in OSD
operation.
“NXT” button: To go to next option function.
“” “” button: To increase setting.
“” “” button: To decrease setting.
“” “” button: To turn the monitor power ON/OFF. The monitor can be turned
OFF only when there is video signal and can be turned ON only when there is
video signal and after the “Turn Off Panel” message vanishes. The default
status is set to ON when power is supplied unless manually turned OFF. Since
this button controls only the display power but not the display controller, please
try disconnect the power cable or the VGA cable once unfortunately the screen
display goes into a mess.
VGA Connector
Power Connector in VGA
Cable
Power Connector from Power
Adaptor
for LM-6212