Filter
Top Products
Part 7
in setup window the switch position 1 to OFF, and position 2 to ON leaving
the rest unchanged as factory default setting.
Parallel Connection
The parallel connector is a 25-PIN D sub Male connector at the
leftmost location in the connector area for PP-8000. Apply the female end of
the parallel cable at this port for parallel application. Please note that when
parallel connection is used, there must be no cable connection at the serial port
on the printer. Please also note that to keep parallel interface in fast operation,
please adjust in setup window the switch position 1 to OFF, and position 2 to
ON leaving the rest unchanged as factory default setting.
LAN Connection
The LAN connector is a 8-PIN RJ45 type modular connector at the
position left to the power connector in the connector area for PP-8000L. Please
use a LAN cable of CAT 5 with proper length to connect the LAN connector
on the printer to the LAN HUB as appropriate. Please note that for PP-8000L,
there must be no cable connection at the serial port or the parallel port on the
printer. Please also note that to keep LAN interface operative, please adjust in
setup window the switch position 1 to OFF, and position 2 to ON leaving
the rest unchanged as factory default setting. DO NOT CONNECT THE
PERIPHERAL DEVICE TO THIS PORT!! The LAN port is 10/100BaseT
compliant.
USB Connection
The USB connector on PP-8000U is a
type B USB connector at lower right position
below the serial port. Use the normal USB Cable
(P/N: 21863250800) as in the left picture to
connect the type A end to a normal USB port of
host system. Please visit our web site
http://www.posiflex.com
or
http://www.posiflex.com.tw
for detailed information of the USB driver
installation if required. Please note that for PP-8000U, there must be no cable
connection at either the serial port or the parallel port on the printer. Set in
setup window the switch position 1 to OFF, and position 2 to ON leaving
the rest unchanged as factory default setting.
Peripheral Connection
The peripheral controller is a 6 pin RJ11 type modular jack. With use
of Posiflex cash drawer cable 21863018010 (CCBLA-180-1) come with cash
drawer, this port can control a Posiflex cash drawer CR3100 or CR3200 or
CR4000 or CR4100 or CR-6310. If a Posiflex special split cable 21863023800
Type A
Normal USB Plugs
Type B